Operation And Display Check; Test And Adjustment 3-1~3-8 - Hammond XK-5 Service Manual

1 Operation and display check

1. Power on with pressing
Keep pressing them until the following screen appears.
2. Operate the SW, drawbar, knob and preset key and check if the variation of the value is
properly.
• SW: While pressing, the name of SW is displayed on the OLED. Lighting the LED
if there is the corresponding LED.
• VIBRATO SW: The corresponding LED is lighted when switching it.
• Drawbar: The screen is switched and drawbar display is changed.
*A# and B are displayed on the same position
• Knob: The value is increased when turning it CW, and decreased when turning CCW
(0 - 127).
*The value knob is required to check the operation of increase and decrease, and not
necessary to check the value to 127.
3. TEST AND ADJUSTMENT
✞ ☎
✝ ✆
OVERDRIVE
✞ ☎ ✞ ☎
✝ ✆ ✝ ✆
EFF REVERB buttons at the same time.
3-1