3/ Decoder Settings; Symbology Default Settings; Symbology Identifier; Voting - Baracoda BBR-LA Programming Manual

3/ Decoder settings

3.1/ Symbology default settings

Sets the defaults decoder settings for all the symbologies

3.2/ Symbology Identifier

AIM Identifier will be transmitted at the beginning of the barcode. More information about the AIM Identifier available in
Appendix2
Symbology identifier - AIM - not transmitted (*)

3.3/ Voting

Standard voting set is 2. This means that a barcode is considered read by the decoder if the same data is
decoded twice. Changing this parameters will enable a stronger security on the decoding of the barcode.
Voting = 2 (*)

3.4/ Disable All Symbologies

Even if all symbologies are disabled, the RoadRunners will always be able to read the programming barcodes of
this document.
Disable all symbologies
© Baracoda 2006
RoadRunners BRR-L Programming guide
Set Decoder Default Settings
Symbology identifier - AIM - transmitted
Voting = 3
Voting = 4
Enable all symbologies
dec 2006
15/29