Maintenance And Inspection; Troubleshooting; Environmental Protection; Available Accessories - Jet JWBS-9X-M Operating Instructions Manual

Start the machine with care.
8. Maintenance and inspection
General note:
Maintenance, cleaning and repair work may only be carried
out after the machine is protected against accidental starting
by pulling out the plug.
Repair and maintenance work on the electrical system may
only be carried out by a qualified electrician.
Clean the machine regularly.
Inspect the proper function of the dust extraction daily.
All protective and safety devices must be re‐attached
immediately after completed cleaning, repair and maintenance
work.
Defective safety devices must be replaced immediately.
Inspect the correct blade tension regularly. Take away the
blade tension if the machine is not in use for a longer time
period.
Inspect the blade guide adjustment regularly.
Check band saw blades regularly for faults. Replace a defective
sawblade immediately.
Cleaning of the Wheels:
The rubber tyre of the wheels must be cleaned regularly.
To tighten the belt
Unplug the machine from power source.
Table insert:
Replace a worn table insert.
The table insert must be made of machinable material (e.g.
wood, plastic, aluminium).
JET part number: JWBS9X‐134
The table insert may not project above table surface.
Saw blades:
The servicing of saw blades should only be performed by a
trained person.
Fig 20
Only use sharp and properly set saw blades.
Replace a defective sawblade immediately.
9. Trouble shooting
Motor doesn't start
*No electricity‐
check mains and fuse.
*Defective switch, motor or cord‐
consult an electrician.
Machine vibrates excessively
*Stand on uneven floor‐
adjust stand for even support.
*dust on wheel‐
clean tires.
*sawblade has cracks‐
replace sawblade immediately
Cut is not square
*Table stop setting wrong.
*Blade guide setting is bad
Cutting surfaces is bad
*Wrong sawblade used
*resin collection on sawblade
*sawblade is dull
*Blade guide setting is bad
*Blade tension too low
*workpiece inhomogeneous
*Feed pressure too high‐
Do not force the workpiece.
Lamp not working
*Lamp defect‐
Replace the lamp bulb (Jet part number: JWBS9‐130)
10. Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.
11. Available accessories
Refer to the JET‐Pricelist
for various saw blades.
11