Maintenance And Inspection; Troubleshooting; Environmental Protection; Available Accessories - Jet JSS-354 Operating Instructions Manual

8. Maintenance and inspection

General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
Clean the machine regularly.
Inspect the proper function of the dust
extraction daily.
All protective and safety devices must
be re-attached immediately after
completed cleaning, repair and
maintenance work.
Defective safety devices must be
replaced immediately.
Cleaning:
Regularly clean the machine housing
with a soft cloth preferably after each
use.
If the dirt does not come off use a soft
cloth moistened with soapy water.
Never use solvents such as petrol,
alcohol, ammoniac water, etc. These
solvents may damage the plastic
parts.
Saw blades:
Only use sharp saw blades.
Lubrication:
Lubricate the arm bearings with light
oil after every 50 hours of use (SAE
20).
9. Trouble shooting
Mot or d oesn＇ t st art
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Machine vibrates excessively
*Stand on uneven surface-
adjust base for even support.
Cut is not square
*Bevel stop setting is bad.
Cutting surfaces is bad
*Wrong sawblade used
*resin collection on sawblade
*sawblade is dull
*sawblade damaged-
replace sawblade immediately
*workpiece inhomogeneous
*Feed pressure too high-
Do not force the workpiece.

10. Environmental protection

Protect the environment.
Your appliance contains valuable
materials which can be recovered or
recycled. Please leave it at a
specialized institution.

11. Available accessories

Stock number 10009939
Set of 5 saw blades 5Z/"
Stock number 10009940
Set of 5 saw blades 7Z/"
Stock number 10002151
Set of 6 saw blades with pin 10Z/"
Stock number 10002152
Set of 6 saw blades with pin 15Z/"
Stock number 10002150
Set of 6 sawblades with pin 18Z/"
7