Table of Contents
Advertisement
PCG10 / K8016
Troubleshooting
The Power LED is not ON
No communication with the computer (check that the cable is connecte d to
parallel printer port, LPT )
Check the printer port setting in the BIOS SETUP of the computer. Select
standard parallel port mode (SPP), also named "compatible" mode or
"Centronics" mode.
No output signal (Ready LED on the front panel is out)
No wave form is selected, select a waveform.
If the above tips have no effect, then test on a different computer or replace the
printer port card.
21
Advertisement
Table of Contents
