Installation; Precautions; Install The Valve And Topworks - ITT Advantage 2.0 Installation And Operation Manual

Installation

Installation

Precautions

WARNING:
• All procedures must be performed by qualified personnel.
• When the process fluid is hazardous, thermal (hot or cold), or corrosive, take extra precautions.
Employ the appropriate safety devices and be prepared to control a process media leak.
• Always wear protective clothing and equipment to safeguard the eyes, face, hands, skin, and lungs
from the particular fluid in the line.
CAUTION:
• Disconnect electrical, pneumatic, and hydraulic power before servicing actuator or automation
components.

Install the valve and topworks

NOTICE:
The topworks size and configuration can limit the actual operating pressure. Consult the engineering
catalog for topworks sizing. Consult the factory or engineering catalog for vacuum operation.
Consider the following information before installing the actuator:
• The series 3, 5, 8, or 16 stainless steel bonnet Advantage actuator 2.0 can have the air inlets positioned
in any quadrant.
• The maximum valve operating pressure is 150 psig (10.34 bar). This pressure is applicable up to 100º
F (38º C). Valves at maximum pressure cannot be used at maximum temperatures.
1. If you have a weld end valve, then consider the following:
2. Install the valve.
8
If you are welding ...
Manually
In line for schedule 10 or heavier pipe Remove the topworks.
In line for schedule 5 or lighter pipe
and tubing
If the valve is a ... Then ...
Dia-Flo diaphragm For horizontal piping systems to be drained through the valve, install the valve
valve spindle between 0º and 30º above horizontal. For vertical piping systems, no
specific orientation is required.
Then ...
Remove the topworks.
You can weld with automatic equipment. Before you perform
the weld:
1. Do not remove the topworks.
2. Set the valve to the open position.
3. Properly purge the valve with an inert gas.
®
Advantage Actuator 2.0 Installation and Operation Manual