ABB SV/S 30.160.1.1 Product Manual page 25

®
ABB i-bus KNX
Start-up
Send status values
Options:
These parameters determine the send behavior of the status values. Status values are:
•
no, update only: The status values are updated but not sent (the values can be read from the
communication objects).
•
after a change: The status values are sent after a change.
•
on request: The status values are sent after a request.
•
after a change or request: The status values are sent after a change or a request.
Enable communication object
"Trigger bus reset" 1 bit
Options:
This parameter enables the communication object to trigger a bus reset, which shorts the bus line for
20 seconds.
•
yes: The 1 bit communication object Trigger bus reset is displayed. An additional parameter is
displayed:
no, update only
after a change
after request
after a change or request
Total current I > Rated current I
Bus current > Rated current I
Overload I > I
max
no
yes
Bus reset on object value
Options: 0
1
0 or 1
0: The bus reset is triggered by object value 0
1: The bus reset is triggered by object value 1
0 or 1: The bus reset is triggered by object value 0 or 1
(SV/S 30.640.5.1 only)
n
(SV/S 30.320.2.1)
n
SV/S xx.xxx.x.1 | 2CDC501049D0201 Rev. A 23