ABB SV/S 30.160.1.1 Product Manual page 10

®
ABB i-bus KNX
Device technology
Protection class
Isolation category
Temperature range
Ambient conditions
Design
Mounting
Mounting position
Weight
Housing, color
Approvals
CE mark
Important
If the device overheats due to extended overload (> 100 °C in housing) it switches off automatically.
The LED is off. The device can be switched on again only after it has been disconnected from the mains
for 60 seconds and has cooled to operational temperature internally.
Eliminate the cause of the overload before switching back on.
When commissioning the device, ensure that the rated current is not continuously exceeded.
The voltage output without choke ( I
only be used to power an additional bus line in combination with a separate choke. It may not,
for example, be used to power IP devices (see SELV guidelines).
Devices are designed for continuous operation. They are not approved for frequent switching on and off.
8 2CDC501049D0201 Rev. A | SV/S xx.xxx.x.1
II
Overvoltage category
Pollution degree
Operation
Storage
Transport
Maximum air humidity
Modular installation device (MDRC)
Main dimensions (H x W x D)
Mounting width
Mounting depth
On 35 mm mounting rail
As required
Approx. 0.25 kg
Plastic housing, gray
KNX under EN 50 090-1, -2
In accordance with the EMC guideline and low
voltage guideline
) is not electrically isolated from the KNX voltage output (I
2
EN 61 140
III under EN 60 664-1
2 under EN 60 664-1
-5 °C...+45 °C
-25...+55 °C
-25...+70 °C
93 %, no condensation allowed
Modular installation device, Pro M
90 x 72 x 64.5 mm
4 x 18 mm modules
64.5 mm
EN 60 715
). It may
1