Table of Contents
Advertisement
Step
6
Pull the cable through the hole and form a drip loop on the outside close to where the cable
enters the building. The drip loop should have a radius of at least 12 inches (30 cm).
To lightning
arrestor & antenna
7
Thoroughly waterproof the lead-in area.
8
Connect the lead-in cable to the SmartLine Transmitter. Tighten cables by hand only; do not
use tools or you could overtighten.
Revision 2
CAUTION
There may be wires in the wall. Before drilling check that the area is clear of any
obstructions or other hazards.
12"/30cm
Drip loop
SmartLine Wireles User's Manual
Action
3. Installation
3.12. Remote antenna
37
Advertisement
Table of Contents
