REQUIRE WELDING FOR INSTALLATION. DO NOT WELD ANY OF THESE COMPONENTS. THE INSTALLTION OF THIS KIT SHOULD BE PERFORMED BY A PROFESSIONAL MECHANIC. THIS STABILIZER KIT WILL NOT WORK ON STOCK HEIGHT VEHICLES IT IS DESIGNED TO WORK ONLY ON VEHICLES WITH FABTECH LIFT SYSTEMS...
Page 2
2. Locate the factory passenger side lower control arm pivot bolt at the front of the vehicle and remove stock nut. 3. Locate the L shaped Fabtech bracket with two holes. Place the bracket with the long leg of bracket up and the short side with the hole over the exposed factory control arm pivot bolt thread.
Need help?
Do you have a question about the FTS8002 and is the answer not in the manual?
Questions and answers