Troubleshooting - Pro-Lift T-5305 Operating Instructions & Parts Manual

TROUBLESHOOTING

Symptom
Hydraulic unit will not lift
load
Hydraulic unit bleeds off
after lift
Lift will not lower after
unloading
Poor lift performance
Will not lift to full extension
For a period of ninety (90) days from date of purchase, SFA Companies, Inc. will repair or replace, at its
option, without charge, any of its products which fails due to a defect in material or workmanship, or which fails to
conform to any implied warranty not excluded hereby.
Performance of any obligation under this warranty may be obtained by returning the warranted product,
freight prepaid, to SFA Companies, Inc. Warranty Service Department, 10939 N. Pomona Ave., Kansas City, MO
64153.
Except where such limitations and exclusions are specifically prohibited by applicable law, (1) the CONSUM-
ER'S SOLE AND EXCLUSIVE REMEDY SHALL BE THE REPAIR OR REPLACEMENT OF DEFECTIVE PRODUCTS
AS DESCRIBED ABOVE, and (2) SFA Companies, Inc. SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL
OR INCIDENTAL DAMAGE OR LOSS WHATSOEVER, and (3) THE DURATION OF ANY AND ALL EXPRESSED
AND IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, ANY WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED TO A PERIOD OF NINETY (90) DAYS FROM DATE
OF PURCHASE.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not
apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
Possible Causes
• Release valve not tightly closed
• Overload condition
• Overload condition
• Hydraulic unit malfunction
• Reservoir overfilled
• Linkages binding
• Fluid level low
• Air trapped in system
• Fluid level low
90 DAYS LIMITED WARRANTY
• Contact Pro-Lift Customer Support
• Remedy overload condition
• Remedy overload condition
• Contact Pro-Lift Customer Support
• Drain fluid to proper level
• Clean and lubricate moving parts
• Ensure proper fluid level
• With ram fully retracted, remove oil filler plug
to let pressurized air escape, then reinstall oil
filler plug
• Ensure proper fluid level
10939 N. Pomona Ave. Kansas City, MO 64153
6
Corrective Action
SFA Companies, Inc.
Phone 1-888-332-6419