Intallation; Mounting The Enclosure - E+E Elektronik EE23 Operation Manual

Humidity/temperature sensor

Hide thumbs Also See for EE23:

Table of Contents

Intallation

4.1

1. Only for model T2 (duct mounting). Drill the hole for inserting the probe into the duct wall,Fig. 7 on

page 11. The relevant position of top left mounting screw of the back cover with respect to the probe

center:

Metal enclosure:

Polycarbonate enclosure:

2. Fix the back cover of EE23 onto the wall / panel using 4 screws (diameter max. 4.2mm (0.2") ; not

included in the scope of supply).

The device shall be mounted with the cable glands pointing downwards or horizontal.

3. Wire the terminals inside the back cover according to „Fig. 10 Connection diagram" on Page 12.

4. Insert the middle (active) part into the back cover. By this the connection pins of the middle part will

plug into the terminals of the back cover and thus realize the electrical connection.

5. Place the front cover onto the middle part and close tight the enclosure using the four screws included

in the scope of supply.

Fig. 5

Mounting of metal enclosure

Fig. 6

Mounting of polycarbonat enclosure

x = 28.5mm (1.1")

y = 37.5mm (1.5")

x = 20.5mm (0.8")

y = 25.4mm (1")

Drilling for round holes:

Drilling for long holes:

Operating manual EE23 humidity / temperature sensor

Table of Contents