Table of Contents
Advertisement
CHAPTER 9: EXTERNAL I/O MODULES
EPM 9450/9650 ADVANCED POWER QUALITY METERING SYSTEM – INSTRUCTION MANUAL
10. The MBIO mounting brackets kit comes with 2 DIN rail mounting clips and an
8mm screw and lock washer for each clip. The clips let you easily mount the
connected I/O modules (or a single I/O module between two brackets) on a
DIN rail. See the figure below.
Figure 9-6: Mounting brackets on a DIN rail
To use the DIN rail mounting clips:
A - From the front of either bracket, insert the screw into the lock washer and
through the hole, and screw it into the clip using an appropriate screwdriver.
Note that the clip should be positioned as shown above, with the indented
side facing the back.
B - Repeat step A for the second bracket.
C - Hook the bottom of the clips around the bottom of the DIN rail and then
push the top of the clips forward so that they fit over the top of the DIN rail.
See the figure below.
Figure 9-7: Detail of DIN mounting clip
USING THE PSIO WITH MULTIPLE I/O MODULES
Fit this over the DIN rail
Hook these under the DIN rail
9–7
Hide quick links:
Advertisement
Table of Contents
