Control Linking; Necessary Equipment - JL Audio VX1000/5i Connection Manual

|

Control Linking:

The small selection boxes
control panels allow you to temporarily link
channels, for simultaneous adjustment. The selection box at the top of the
panel selects all channels with one click.
Control Linking is incredibly useful, permitting you to execute changes in
multiple channels, while listening to the effect of these changes in real time.
For example, you could select both the left and right tweeter channels and
adjust delay on them, together, while retaining any offset that exists between
them. You can flip the polarity of multiple channels and listen to the result in
real time, or adjust the levels of multiple channels together.
Control Linking is available for the following controls:
Speaker Distance
Polarity
Pre-Crossover Level Trim
High-Pass Filter (Slope changes trigger auto-mute, except in Expert Mode)
Low-Pass Filter (Slope changes trigger auto-mute, except in Expert Mode)
Additional Delay
Output Level Trim
PLEASE NOTE: CONTROL LINKING IS A TEMPORARY ADJUSTMENT STATE
AND IS NOT SAVED IN THE PROJECT FILE.
Appendix A:
Twk™ Input Sensitivity Level Setting
Selecting the appropriate Input Sensitivity setting is critical to achieving
maximum, low distortion output. To properly set the TwK's Input Sensitivity
settings, perform the steps below prior to making any amplifier adjustments.

Necessary Equipment

• CD or file with a pink noise test track.
1. After all wiring is complete, connect your TwK™ to a PC and launch the
TüN™ software. Configure your project, then press the "Master Mute"
button to mute all TwK™ outputs.
2. Turn off all processing (bass/treble, loudness, EQ, etc.) on the source unit
and processors (if used). Set the source unit's fader and balance controls to
center.
3. Set the source unit volume to ¾ of maximum. This will allow for
reasonable gain overlap with moderate clipping at full volume.
4. Select the Input "Menu"
pink noise track (at ¾ source unit volume).
5. Click the dropdown arrow for the first input channel and, using the
"Signal Level Meter"
exceed the yellow bars. Repeat for the remaining input channels.
Note: When using JL Audio amplifiers, set the amplifier's Input Sensitivity
control to twelve o'clock (noon) and Input Voltage switch (if equipped)
to "Low".
that correspond to each channel in various
the controls for multiple
from the SETUP tab and begin playing the
as a guide, select the setting that does not
Page 15