Getting Started - JL Audio VX1000/5i Connection Manual

GETTING STARTED

To start a New Project, select "Create a New Project" from the Startup Dialog Box
or "New Project" from the toolbar on the left side of the interface. Whenever
a new PROJECT is created, a New Project Setup Tool window pops up in front of
the TüN™ interface. This tool is designed to quickly and efficiently establish the
starting parameters for your PROJECT. Here, you will name the PROJECT, enter
the vehicle information, add a few notes if you want, and then click "Next" .
In the second page, you will be asked to make a few selections. The answers
you provide will allow the TüN™ software to create a safe, baseline starting
configuration for tuning your system, saving you a lot of data entry time. The
selections you will make are as follows:
Project Level: Sometimes you need maximum flexibility and complexity,
and sometimes you don't. To address your particular Project with
appropriate complexity, the TüN™ software offers three Project Level
choices: Basic, Advanced or Expert.
Basic: offers a streamlined feature set with common sense safeguards
designed for efficient system tuning. It is ideal for first time DSP users and
time-sensitive projects. You will have access to the Input Mixer and Router,
DRC Setup, Output Polarity, 10-band Graphic Equalizers, High-Pass and
Low Pass Filters (12, 24 or 48 dB/octave, Linkwitz-Riley) and Level
Trim controls.
Advanced: offers a full feature set with restrained safeguards to prevent
accidental damage to the audio system. This is ideal for experienced DSP
users looking to get full advantage of the TwK's power, while avoiding
certain pitfalls that can result in poor performance or speaker damage. You
will be able to access all the Basic Level features listed above, plus summing
polarity, fully parametric 10-band EQ's and channel delays.
Expert: offers the complete feature set with no safeguards. This level is
only for expert users who have no need for technical support. Additional
crossover filter slopes and alignments are added with the following
safeguards and constraints disabled: crossover frequency safety mute,
parametric EQ boost limits and automatic summing level. You can easily get
very bad sound and/or speaker damage if you are not careful.
When in doubt, choose "Advanced".
Changing Project Levels of an existing Project: If you begin a Project at
one Project Level and wish to change to a higher Project Level, this can be
accomplished with "Project Settings"
IMPORTANT: ONCE YOU MOVE A PROJECT INTO A HIGHER PROJECT
LEVEL, IT CANNOT BE RETURNED TO A LOWER PROJECT LEVEL. IF YOU
THINK YOU MIGHT NEED TO GO BACK, CREATE A COPY OF THE PROJECT
AND STORE IT IN YOUR PC, BEFORE CHANGING THE PROJECT LEVEL.
Page 6
.
IMPORTANT
|