Siemens MJ-XL Installation And Operation Manual page 32

4
Setting Up the MJ-XL Control Panel
administrator. This person would be responsible for estab-
lishing the password protection scheme and for making
changes to the passwords as necessary; He/she would be
the only individual requiring knowledge of the "System
Key." The "System Key" not only allows the user to
change the security system, it also acts as a top level
password which allows access to all change/reset func-
tions. Once the "System Key" is entered and until the
session is ended, the security system is effectively dis-
abled.
The <PASSWORD> Menu
Table 4.6
Data item
The following data items are used to enter passwords
Enter PW: Prompts operator for a password
End Session ? End password access to protected data items
System Key: Prompt for entering and changing of the System Key
The following data items are visible only after System Key has been accepted.
Level 1: Enable Level 1?
Level 1 PW: Level 1 password
Configure: Enable password for <CONFIGURE> Menu changes
Config PW: Password for <CONFIGURE> Menu
Regulator: Enable password for <REGULATOR> Menu changes
Reg. PW: Password for <REGULATOR> Menu
Meter: Enable password for <METER> Menu changes
Meter PW: Password for <METER> Menu
Demand: Enable password for <DEMAND> Menu changes
Demand PW: Password for <DEMAND> Menu
Alert: Enable password for <ALERTS> Menu changes
Alert PW: Password for <ALERTS> Menu
Counters: Enable password for <COUNTERS> Menu changes
Counters PW: Password for <COUNTERS> Menu
Log Setup: Enable password for <LOG SETUP. Menu changes.
Log Set PW: Password for <LOG SETUP> Menu
Ev/Intv: Enable password for <EVENT LOG> and <INTERVAL LOG> Menus.
Ev/Intv PW: Password for <EVENT/INTERVA>L
Harmonics: Enable password for <HARMONICS> Menu.
Harm. PW: Password for <HARMONICS> Menu
Comm: Enable password for <COMMUNICATIONS> Menu.
Comm PW: Password for <COMMUNICATIONS> Menu
Diagnostics: Enable password for <DIAGNOSTICS> Menu.
Diagnos. PW: Password for <DIAGNOSTICS> Menu
28
4.6.2 The MJ-X
The <PASSWORD> Menu serves three purposes:
1. To enter passwords so that you can change/reset
password-protected data items.
2. To define passwords.
3. To activate and de-activate security checking.
Table 4.6 below describes the data items in the <PASS-
WORD> Menu and their default settings.
Description
Level 1
Level 2
Siemens Power Transmission & Distribution, Inc.
L
<PASSWORD> Menu
Value
xxxx
N or Y
xxxx 0123
OFF or ON
xxxx 1111
OFF or ON
xxxx 2222
OFF or ON
xxxx 2222
OFF or ON
xxxx 2222
OFF or ON
xxxx 2222
OFF or ON
xxxx 2222
OFF or ON
xxxx 2222
OFF or ON
xxxx 2222
OFF or ON
xxxx 2222
OFF or ON
xxxx 2222
OFF or ON
xxxx 2222
ON or Off
xxxx 3333
Bold denotes default values