Hardware Configuration- The <Diagnostics> Menu - Siemens MJ-XL Installation And Operation Manual

4
Setting Up the MJ-XL Control Panel
4.8 Hardware Configuration—
the <DIAGNOSTICS> Menu
The <DIAGNOSTICS> Menu includes the MJ-X
ware configuration items in addition to the calibration and
L
MJ-X internal test items.
See Section 8 for information about the test and calibra-
tion items:
U2 Cal
P2 Cal
C/C2low
C/C2med
C/C2high
L
The MJ-X provides three hardware configuration items to
assure compatibility between the MJ-X
L
ware) and the MJ-X control program software. The hard-
ware configuration items are listed in Table 4.10 below:
Hardware Configuration Items
Table 4.10
DATA ITEM
MP BD VERS: MJ-X
PWR BD VERS: For MJ-X Compatibility. (In MJ-X
used only for Enabling Alternate Tap
Tracking Algorithm.)
MP MASK VERS: MJ-X
The Hardware configuration items are initialized at the fac-
tory. Normally, these items will not need to be changed or
updated.
32
L
hard-
L
electronics (hard-
DESCRIPTION
L
Main Processor Board Version
L
,
L
Microprocessor Mask Version
L
For all MJ-X units, the "MP MASK VERS:" item is factory
set to "0C." This is the default setting and the operator/
installer should leave it set for this value.
Refer to MJ-X Application Note 006: Alternate Tap Track-
ing Algorithm for other settings of these parameters.
The <DIAGNOSTICS> Menu also includes the Serial
Number and Product Revision code for the MJ-X
Panel. These are set at the factory and cannot be
changed.
Refer to the MJ-XL Communications Module Instruction
Manual for information about the Comm Module items:
CM Test?
CM TestStat
Siemens Power Transmission & Distribution, Inc.
L
Control