Graco EnDure Instruction Manual page 6

FIRE, EXPLOSION, AND ELECTRIC SHOCK HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and result in fire or
explosion and serious injury.
•
Ground the equipment and the object being sprayed. The Heated Automatic Dispense Valve is grounded to truth
earth ground inside the electrical control panel. See Grounding on page 9.
•
Ground the equipment and the object being sprayed, and all other electrically conductive objects in the dispense
area. Proper grounding dissipates static electricity generated in the equipment. See Grounding on page 9.
•
Do not use this equipment with flammable liquids.
•
Keep the dispense area free of debris, including solvent, rags, and gasoline.
•
If there is any static sparking or you feel an electric shock while using the equipment, stop dispensing
immediately. Do not use the equipment until you have identified and corrected the problem.
•
Make sure all electrical work is performed by a qualified electrician only.
•
Have any checks, installation, or service to electrical equipment performed by a qualified electrician only.
•
Make sure all electrical equipment is installed and operated in compliance with applicable codes.
•
Make sure power is disconnected when servicing and repairing equipment.
•
Before operating the equipment, extinguish all open flames or pilot lights in the dispense area.
•
Do not smoke in the dispensing area.
•
Keep liquids away from the electrical components
•
Disconnect electrical power at the main switch before servicing the equipment.
•
Never exceed maximum wattage of the supply unit.
TOXIC FLUID HAZARD
Hazardous fluids or toxic fumes can cause serious injury or death if splashed in the eyes or on the skin, swallowed,
or inhaled.
•
Provide fresh air ventilation to avoid the buildup of vapors from the fluid being dispensed.
•
Know the specific hazards of the fluid you are using.
•
Store hazardous fluid in an approved container. Dispose of hazardous fluid according to all local, state and national
guidelines.
•
Always wear protective eyewear, gloves, clothing and respirator as recommended by the fluid and solvent
manufacturer.
•
Avoid exposure to heated material fumes.
6
WARNING
309376L