Maintenance - Husqvarna 320iB Mark II Operator's Manual

To set the optimal airflow for your
work
1. Press the power trigger to choose the optimal airflow
for your work.
2. Press the cruise control button to set the chosen
airflow, the LED comes on.
3. Continue to work without needing to press the power
trigger.
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.

Maintenance

Clean the outside of the machine with a clean and dry cloth. Never use water.
Keep handles dry, clean and free from oil and grease.
Make sure that the start/stop button works correctly and is not damaged.
Make sure the power trigger is functioning properly with regard to safety.
Check that nuts and screws are tight.
Check that the battery is intact.
788 - 002 -
4. Press the cruise control button again to deactivate
the cruise control function.
To temporarily increase the airflow
1. Start the product. See
10 .
2. Press and hold the boost button to get the maximum
airflow, the LED comes on.
a) 525iB, 530iBX has unlimited boost time.
b) 320iB Mark II has a limited boost time of 30
seconds. Release and press the boost button
again.
3. Release the boost button to use the product with
normal air flow.
Maintenance
Maintenance schedule
The following is a list of the maintenance steps that you
must do on the product.
To start the product on page
WARNING: Remove the battery before you
do maintenance.
Daily Weekly
X
X
X
X
X
X
Monthly
11