Related Manuals for Nexa NEYCR-1500
Summary of Contents for Nexa NEYCR-1500
- Page 1 NEYCR-1500 + PET-910 Manual Specification 3 on/off receivers + remote control Frequency 433.92MHz Battery in remote control: 1 x 3V CR2032 (included) Maximum number of transmitters: 3 The receivers are compatible with other teachable transmitters in System Nexa.
- Page 2 Programming 1. Connect a bulb to the receiver 2. Place the receiver in the wall socket 3. The LED on the receiver will now flash for 5 seconds while the receiver is in learning mode. 4. Press the ON button on the remote control with which you want to control the receiver.
- Page 3 Delete memory in receiver Each receiver has memory for three different transmitters. Once the memory is full, you can either delete the entire memory or one specific transmitter. Delete the entire memory 1. Connect a bulb or other load to the receiver 2.
-
Page 4: Battery Replacement
ON/OFF & ALL OFF Press "ON" to turn on the connected bulb. Press "OFF" to turn off the connected bulb. Press "ALL OFF" to turn off all receivers Dimmer The remote control can also be used for receivers with dimmer (not included) and then operates in the following manner. -
Page 5: Troubleshooting
Memory in receiver full; follow the instructions "Delete memory in receiver" and then try again. Specification Receiver NEYCR- 1500 Frequency 433.92MHz Maximum number of transmitters: 3 Operating voltage: 220-240 V ~50Hz Max. load: 1500W resistive load. Transmitter PET-910 Frequency 433.92MHz Battery in remote control: 1 x 3V CR2032 (included) Support: support@nexa.se www.nexa.se...
Need help?
Do you have a question about the NEYCR-1500 and is the answer not in the manual?
Questions and answers