4.3
Performing Weekly Maintenance
4.3.1 Steps: Cleaning and Inspecting the Inspection Head
Housing
4.3.2 Steps: Inspecting the External Wiring and Conduit
for Damage
4.3.3 Steps: Verifying the Beacon
4-4
Complete these steps to clean and inspect the housing around the
inspection head.
1.
Turn off the main power switch.
2.
Inspect for damage including the name plate, safety
stickers, labels, and instruction plates.
3.
Wipe with a clean, soft, damp cloth.
•
Do not wash with a high pressure nozzle.
•
Do not steam clean.
Complete these steps to inspect the external wiring and conduit.
1.
Turn off the main power switch.
2.
Check the external wiring between the sensors and the
FT-100/CI or FT-170/CI for damage. Check all connections
carefully to ensure that they are not loose.
3.
Check that insulating sleeves are in place.
4.
Report any problems to your service department.
Complete these steps to verify that the beacon is operating
correctly.
1.
On the
MASTER
Test
Beacon, and then press the Enter key on the control
panel.
2.
Does the beacon flash?
MENU, first select
Diagnostic
FT-100/CI and FT-170/CI Operation Guide
Displays, then
Document 40275-0913