Information For The User - Digigram IQOYA *LINK User Manual

1 INFORMATION FOR THE USER

This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of the FCC
Rules and with the following European and international Standards for:
User safety:
European Directive 2006/95/EC "Low Voltage
Directive
Europe: EN60950 1 (2006)
International: IEC 60950 1 (2005)
RoHS:
European directive 2002/95/EC aka "RoHS"
In order to guarantee compliance with the above standards in an installation, the following must be done:
· the provided cables must not be modified.
· additional cables used must have their respective shield connected to each extremity.
The limits specified in the standards are designed to provide reasonable protection against harmful interference in an industrial
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
* reorient or relocate the receiving antenna.
* increase the separation between the equipment and the receiver.
* connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
* consult the dealer or an experienced audio/television technician for help.
Note: Connecting this device to peripheral devices that do not comply with CLASS A requirements or using an unshielded
peripheral data cable could also result in harmful interference to radio or television reception. The user is cautioned that any
changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate this equipment. To ensure that the use of this product does not contribute to interference, it is necessary to use
shielded I/O cables.
©​
EMC:
United States: FCC rules Part 15 Class B
International: CISPR22 (2005) Class B + A1/2005 + A2/2006
European Directive: EMC 2004/108/EC
Europe: Disturbance Emissions: EN55022 (2006) +A1/2007
Requirements for Information Technology Equipment (ITE)
Immunity: EN55024(1998+A1/2001+A2/2003) (ITE)
Harmonics: EN61000-3-2 (2006)
Note: to comply with standard EN55024, use shielded
network cables!
5