Digigram IQOYA *LINK User Manual page 23

Type the new IP address into the address bar of the browser to access the IQOYA *LINK again.
Do the same for the "ETH1" network interface (IP Backup/Control) if required. By default ETH1 is disabled.
Make sure that Eth0 and Eth1 have IP addresses belonging to different subnets.
If you want to configure VLANs, select the VLAN from the "Network" menu (Eth0 VLAN 1, Eth0 VLAN 2,
Eth1 VLAN 1, and Eth1 VLAN 2).
● Enable or disable the VLAN in the "Status" field.
● Enter the parameters of your VLAN: VLAN ID, VLAN priority, IP address of the equipment in this VLAN, and
subnet mask.
Make sure that Eth0, Eth1, Eth0.Vlan1, Eth0.Vlan2 ,Eth1.Vlan1, Eth1.Vlan1 have IP addresses
belonging to different subnets.
● Confirm the settings by clicking on 'Apply'.
From the "Preferences" page, you can view the IP routing table from the menu Network, IP routing.
● If you want to modify the routing table, first download the current table. Click on "Configure" and click on
"Download IP Table".
22