Installation Instructions; Step 1: Check The Door Balance; Step 2: Adjust The Leveling Legs - Insignia NS-DWH2BS8 Installation Manual

NS-DWH2_BS8_SS8_NS-DWR2_BS8_WH8_SS8_17-0939_Install MAN_V5_ENG.fm Page 10 Wednesday, January 24, 2018 2:49 PM

Installation instructions

Step 1: Check the door balance

Caution:
• Opening the door of your dishwasher before it is installed will cause it to tip forward. Do not open the door until you are ready to
install your dishwasher.
• If it is necessary to open the door, hold the top of the dishwasher securely with one hand and hold the door with the other hand.
1 Hold the top of the dishwasher firmly.
2 Open the door slowly, then release it. If the door drops, increase the spring tension. If the door closes, decrease the
spring tension.
3 Continue moving the spring pin until the door is balanced. Adjust both springs to the same tension.

Step 2: Adjust the leveling legs

1 Move the dishwasher close to the installation location and lay it on its back.
Note:
Make sure that the leveling feet are loosened before standing the dishwasher upright. They may be tight from
shipping/packaging.
2 Measure the installation height and the dishwasher height.
3 Extend the leveling legs out from the dishwasher base .25 in. (6.35 mm) less than the installation height.
Adjust to .25 in. (6.35 mm)
less than the installation
height
10
Increase
Decrease
www.insigniaproducts.com
Top Control Dishwasher
Adjust to .25 in. (6.35 mm)
less than the installation
height