Step 3: Remove The Toekick; Step 4: Install To Power - Insignia NS-DWH2BS8 Installation Manual

NS-DWH2_BS8_SS8_NS-DWR2_BS8_WH8_SS8_17-0939_Install MAN_V5_ENG.fm Page 11 Wednesday, January 24, 2018 2:49 PM

Step 3: Remove the toekick

• Remove the two toekick screws with a Phillips screwdriver, then remove the toekick.
You'll need:

Step 4: Install to power

Turn off the electricity to the dishwasher's electrical circuit.
Make sure that the electrical power is turned off at the source.
Warning:
•If your house wiring is not 2-wire with a ground, a ground must be provided by the installer.
•If your house wiring is aluminum, be sure to use cUL/UL Listed anti-oxidant compound and aluminum-to-copper
connectors.
Power cord
1 Remove the junction box cover on the front right of the dishwasher.
2 Make sure that the junction box's electrical wires are pulled inside of the junction box.
3 Remove the lock nut from the strain relief, then push the strain relief into the round opening of the junction box.
4 Install the lock nut on the strain relief from inside the junction box.
5 Insert the ends of the power cord's electrical wires into the junction box through the strain relief.
6 Connect the incoming white (or ribbed) wire to the dishwasher's white wire, the black (or smooth) wire to the
dishwasher's black wire, and the ground wire to the dishwasher's green wire. Use cUL/UL listed wire nuts of the
appropriate size.
7 Tighten the strain relief screws and lock nut to stabilize the power cord's electrical wires, then make sure that all of the
connections are secure.
Adjustable wrench
www.insigniaproducts.com
NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8
Phillips screwdriver
11