Tuttnauer EZPlus Autoclave Operating Instructions

EZPlus Autoclave Operating Instructions
Keep these instructions with or near your autoclave for easy reference.
For detailed operating instructions refer to EZPlus Operators Manual.
Turn the unit on by setting the rocker switch mounted on the right side of the front panel to
the "On" position.
NOTE: The EZ11Plus has an automatic pre-heating mode which activates automatically in the
"Wrapped Instruments, Pouches", "Handpieces", and "Custom A" cycles. Use caution since
pre-heating will make the bottom of the chamber hot. (This feature is not active in the
EZ9Plus.)
Once the system software has finished loading System Ready will flash across the screen
followed by the fill reservoir icon.
•
Place your thumb on the plastic door cover and the other fingers in the handle pocket.
•
Pull the handle until the latch of the door is released.
The EZPlus is equipped with an electronic door lock. The door will be remain locked if:
a. The power is off
b. The EZPlus is running a cycle and the cycle has not completed.
c. An error message is displayed (this is cleared by pressing the STOP key)
d. There is water in the chamber. and this icon
Fill the reservoir by pouring steam distilled water, gently, into the front funnel until it reaches
the top of the blue area on the level gauge. This reservoir is designed with an overflow and
filling the reservoir above the safe level as indicated on the Front Fill Funnel will cause excess
water to spill out below the machine onto the counter
Select a program to run by using the "UP" or "DOWN" arrow keys. (Programs can only be
selected when the door is open.)
Unwrapped Wrapped
Instruments Instruments
270ºF Pouches
270ºF
Tuttnauer USA., Co., Ltd.
25 Power Drive, Hauppauge, NY 11788. Tel: +800 624 5836, +631 737 4850 Fax: +631 737 0720
E-mail: info@tuttnauerUSA.com, www.tuttnauerUSA.com
The door can be opened by following these steps:
appears on the screeen.
.
Unwrapped Handpieces
Delicate 270ºF
Instruments
250ºF
Power switch