Mitsubishi Electric FX2N-64DP-M Hardware Manual page 13

FX2N-64DP-M Profibus-DP Master Block
c) RS-232C port (9-pin D-SUB Connector: #4-40unc inch screw thread)
The cable connecting between 64DP-M and personal computer is Blue ProfiCab cable.
For Blue ProfiCab, refer to MELSEC ProfiMap Configuration System for Open Networks
Software Manual.
d) Status LEDs
Table 1.1: Status LEDs
LED Name
RUN LED
SD/RD LED
TOKEN LED
READY LED
FROM/TO LED
PRM.SET LED
RSP ERR LED
FAULT LED
e) POWER LED: ON when 24V DC power is supplied form the external power supply or
ON: During normal operation
OFF: Error
Flashes during communication with slave on the Profibus network. The
flashing interval is the time interval of the bus parameter's Data Control Time.
ON when token is maintained.
ON when the Profibus-DP network subscription preparation is completed and
during subscription.
ON when a FROM/TO instruction from the programmable controller is
operating.
ON (PARAMETER SET) when in the parameter setting mode. When flashing
during operation, the parameter is not written.
ON when a communication error occurs.
ON when an error occurs.
FX series PLC.
2N
Description
Introduction 1
1-3