How To Add A Device To A Z-Wave Network; How To Test The Z-Wave Device; How To Program The Z-Wave Device - Axis T8343 User Manual

Table of Contents

AXIS T8343 Alert Button

How to add a device to a Z-Wave Network

Auto inclusion

The detector supports the auto inclusion feature where it will automatically enter Inclusion mode when first powered up. This will

also apply when powered up after a factory reset.

Carefully remove the front cover by pulling the bottom of the front cover. There is a link button which is used to put the

device in learning mode (inclusion/exclusion).

2. Put a Z-Wave controller into inclusion mode.

3. Insert 2 AAA-batteries (1,5V) into the battery compartment with the correct polarity. The LED on the device should turn ON

4. The inclusion process should be completed when the LED stops blinking

Manual inclusion

You can also choose to manually add the Z-Wave device to a control device. Please follow the steps described below.

Note

For best results, exclude the device before starting the inclusion process. For more details see the installation guide

1. Press the link button 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.

2. The inclusion process should be completed when the LED stops blinking

3. Perform a test before you refit the cover.

Manual exclusion

Note

For more details see the installation guide

1. Detach the battery cover.

2. Press the link button 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.

3. The exclusion process should be completed when the LED stops blinking

4. Refit the battery cover.

A scene needs to be created for the Alert button to control other devices on the Z-Wave controller. Scenes are user defined elements

in the controller that determines what actions to take when an event occurs. The Alert button triggers the event for the Scene

which then controls other activation devices such as plugs or dimmers, or perhaps set an alert to alarm or Disarm mode. An alarm is

triggered after a short press. To disarm, perform a 10 seconds long press.

•

After you have included the device in the network with the Z-Wave controller, the Alert button will send data about its

battery power to the Gateway after about 2 minutes. After that, it will only send data once the button is pressed

Note

Programming Z-Wave devices using a Z-Wave controller, like the AXIS M5065 PTZ Network Camera, is recommended

for experienced users only.

Table of Contents