Appendix; Maintenance; Restrictions On O Il Ing; Precautions On Storing The Machine - Brother 888-X64 Operation Manual

6 APPENDIX
MAINTENANCE
Restrictions on olllng
>
In order to prevent damaging this machine, it must not
be oiled by the user.
This machine was manufactured with the necessary
amount of oil applied to ensure correct operation,
making periodic oiling unnecessary.
If problems occur, such as difficulty turning the
handwheel o r an unusual noise, immediately stop using
the machine, and contact your authorized Brother
Service Center or the nearest authorized Brother Service
Center.
Precautions on storing the
machine
Do not store the machine in any of the locations
described below, otherwise damage to the machine
may result, for example, rust caused by condensation.
• Exposed to extremely high temperatures
• Exposed to extremely low temperatures
• Exposed to extreme temperature changes
• Exposed to high humidity or steam
• Near a fl ame, heater or air conditioner
• Ouldoors or exposed to d irecl sunlighl
• Exposed to extremely dusty or oily environments
~ Note
- - - - - - - - - -
• In order to extend the life of this machine,
periodically turn it on and use ii.
Storing this machine for an extended period
of time without using it may reduce its
efficiency.
Clean Ing
>
A.CAUTION
• Make sure you unplug the machine
before you clean it, otherwise you risk
getting an electric shock or being
injured.
0
e
e
Turn off the machine and unplug it.
Raise the needle and the presser foot.
Loosen the presser foot screw and the
needle clamp screw to remove the presser
foot holde r and the needle.
Using the screwdriver, remove the two
screws. Lift up the needle plate as shown
in the illustration, and then slide the
needle plate to the left to remove it.
©
Use the screwdriver
Grasp the bobbin case, and then lift it out
to the left ..
40