Brother 888-X64 Operation Manual page 39

Darning
>
Straight Stitch
7
Darning
(Center Needle
T
1.8 (1/8)
Position)
Plate
Straight Stitch
8
Darning
..,
2 ( 1/16)
(Center Needle
I
Position)
I
Plate
I
Straight Stitch
9
Darning
..,
(Center Needle
I
3 (1/8)
Position)
I
Plate
I
Straight Stitch
10
Darning
et>
(Center Needle
I
4 (3/16)
Position)
Plate
Stra\f';t Stitch 11
Darning
(Le Needle
0
2.5 (3/32)
I
Plate
Position)
I
I
Turn off the machine.
0
Place the darning plate on the needle
e
plate, then tum on the machine.
Either remove both the presser foot and
presser foot holder assembly and then
lower the presser foot lever.
Put the section you want to darn under
the presser foot together with fabric for
reinforcement.
Turn on the machine.
AcAu110N
• Do not turn on the machine while pressing
down the foot controller. The machine
may start unexpectedly and cause
personal injury or damage to the machine.
Begin sewing by alternating between
gently drawing the work away from you
and pulling it toward you.
~ Note ----------
• Sew while holding the fabric stretched in
order to keep the fabric held down.
Repeat this motion until the section being
darned is filled with parallel lines of
stitching.
38