Table of Contents
Advertisement
To format a ZS Sensor
Formatting a sensor clears its flash memory. Do either of the following to format a sensor:
Download the controller that the sensor is connected to.
Do the following:
a)
Remove the wiring connector from the sensor.
b)
Note the current position of the DIP switches.
c)
Set all DIP switches to the ON position.
d)
Reattach the wiring connector to format.
e)
After approximately 3 seconds, remove the wiring connector.
f)
Set the DIP switches back to their original position.
g)
Reattach the wiring connector.
NOTE
NOTE If you move a sensor from one controller to another controller that has a different control program, format
the sensor.
AURORA UPC ZS ZONE SENSORS INSTALLATION GUIDE
15
Advertisement
Table of Contents
Need help?
Do you have a question about the UPC ZS ZONE SENSOR and is the answer not in the manual?