Power Connection - zapco DC-352 Owner's Manual

DC-352/DC-752/DC-364/DC-1004/DC-501/DC-1101/DC-656
+12V Power
Connect the +12V terminal of the amplifier to the + terminal of the battery using the same diameters
the ground cable,
making sure you install in-line fuse holder, approximately 300 or 400 mm.
From the + terminal of battery, making sure that there is no fuse in the battery holder.
GROUND
Disconnect the battery and connect the GND (ground) terminal to the cars chassis.
Keep this cable as short as possible (not longer than 500 mm. or less).
Making sure that the connection with the chassis is rust free and clear of paint or grime.
REMOTE
Connect the REM terminal of the amplifier to the power antenna terminal in the car ignition switch
using 12 or 16 ga. electrical wire.
First make the ground connection, then +12V wire connection, and finally the remote
connection. Furthermore, the +12V wire must always be fused at the battery for protection
against possible damage. nIf you need to replace the power fuse, replace it with a fuse of
the same value. It may result in a serious hazard to use a fuse of a different type or rating.

POWER CONNECTION

FUSE
BATTERY
GROUND
Caution
+12V TURN ON GND
to REMOTE Turn-on
from HEAD UNIT
-22-
GROUND
HEAD UNIT