YSI MultiLab IDS 4310 Operation Manual page 5

4310(W)
Opening the plug
connection
Closing the plug
connection
Outside cleaning
ba76139d02 10/2017
4
3
Guidance
Groove
 If necessary, clean the plug connection
 Open the locking device (step 1)
 Use your thumb and index finger to press the clips of the connector
together, and pull the connector out of the plug (step 2).
 Make sure that the plug connection is completely dry and clean.
 Align the guidance of the connector with the groove in the plug and insert
the connector in the unlocked plug until it catches (step 3).
 Close the locking device (step 4).
3 Cleaning
NOTE
Prior to cleaning, disconnect the sensor from the meter.
We recommend to clean the sensor thoroughly, especially before measuring
low conductivity values.
Plug connection
closed and locked
Cleaning
1
2
5