Page 5
Identification Key Controller On/Off Button LCD Screen Horn Button Profile Decrease Button Hazard Button Left Turn Indicator Button Joystick Light Button Right Turn Indicator Button Profile Increase Button Charger Port Mode/Actuator and Power Switch Input...
Page 6
Identification Key Attendant Control Mode Button Mode LED Actuator Indicators Battery Condition Meter On/Off Button Joystick On/Off and Mode Jacks...
Page 7
Safety Guidelines WARNING! A Quantum Rehab Provider or a qualified technician must perform the initial setup of this product and must perform all of the instructions in this manual. The symbols below are used throughout this owner’s manual and on the controller to identify warnings and important information.
Avoid exposure to rain, snow, ice, salt, or standing water whenever possible. Maintain and store in a clean and dry condition. EMI/RFI—This product has been tested and passed at an immunity level of 20 V/m. Disposal and recycling—Contact your Pride/Quantum Rehab Provider for information on proper disposal and recycling of your Pride product and its packaging.
NE+ Controller The NE+ controller is a fully programmable, modular electronic controller system that allows you to operate your power chair. It is designed to allow the user to have complete control over chair movement and speed. The controller has been pre-programmed to meet a typical user’s needs. The program is set using either a personal computer with software provided by the controller manufacturer or with a hand-held programmer, also provided by the controller manufacturer.
The drive profile may be changed by pressing the profile decrease key or the profile increase key. NOTE: Drive profiles are set by your Pride/Quantum Rehab Provider. Contact your Quantum Rehab Provider to change or add a drive profile.
2. Press the drive profile decrease or drive profile increase button until you reach the desired speed/ profile setting. NOTE: Drive profiles are set by your Pride/Quantum Rehab Provider. Contact your Pride/Quantum Rehab Provider to change a drive profile or change speed settings.
4. Press and hold the switch again to lower the actuator. NOTE: Function of the mono jack on the joystick is set by your Pride/Quantum Rehab Provider. Contact your Pride/Quantum Rehab Provider to change the function of the jack. (For two actuators, a splitter harness will be needed.)
Attendant Control Joystick For more information on this application, contact your Pride/Quantum Rehab Provider. The Attendant Control is for use by an ambulatory attendant and has the following controls: On/Off Button Enables/disables power Battery Condition Meter Indicates battery charge ...
If the problem persists or you receive any other error code or experience any other problem with your power chair, contact your Pride/Quantum Rehab Provider. *If the fault does not reset after performing the solution, contact your Pride/Quantum Rehab Provider. Icon Display...
Page 16
*If the fault does not reset after performing the solution, contact your Pride/Quantum Rehab Provider. Icon Display Diagnosis Solution Left Indicator Fault Press left indicator key.* Right Indicator Fault Press right indicator key.* Hazard Indicator Fault Press hazard key.* Running Lights Fault Press light key.*...
Care and Maintenance Refer to your power chair owner’s manual for proper cleaning and disposal instructions. Temperature Some parts of your power chair are susceptible to extreme changes in temperature. Always keep your power chair between the temperature of 18°F (-8°C) and 122°F (50°C). Warranty Refer to your power chair owner’s manual for specific information on controller warranty.
Page 20
401 York Avenue Duryea, PA 18642 Canada 5096 South Service Road Beamsville, Ontario L0R 1B3 32 Wedgwood Road Bicester, Oxfordshire OX26 4UL www.quantumrehab.co.uk Australia 20-24 Apollo Drive Hallam, Victoria 3803 www.quantumrehab.com.au New Zealand 38 Lansford Crescent Avondale Auckland, New Zealand 1007 www.pridemobility.co.nz Italy Via del Progresso, ang.