Appendix D: Compliance Information; Installer Compliance Responsibility; Fcc; Ised Canada - Ubiquiti airFiber 24 User Manual

airFiber AF-24/AF-24HD User Guide
Appendix D: Compliance
Information

Installer Compliance Responsibility

Devices must be professionally installed and it is the
professional installer's responsibility to make sure the
device is operated within local country regulatory
requirements.

FCC

Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
when the equipment is operated in a commercial
environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operations of this equipment in a residential area is likely
to cause harmful interference in which case the user will
be required to correct the interference at his own expense.

ISED Canada

CAN ICES-3(A)/NMB-3(A)
This device complies with ISED Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including
interference that may cause undesired operation of the
device.
CAN ICES-3(A)/NMB-3(A)
Le présent appareil est conforme aux CNR d'ISDE Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
1. l'appareil ne doit pas produire de brouillage;
2. l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Ubiquiti Networks, Inc.

Appendix D: Compliance Information

RF Exposure Warning

The antennas used for this transmitter must be installed
to provide a separation distance of at least 107 cm from
all persons and must not be located or operating in
conjunction with any other antenna or transmitter.
Les antennes utilisées pour ce transmetteur doivent être
installé en considérant une distance de séparation de
toute personnes d'au moins 107 cm et ne doivent pas être
localisé ou utilisé en conflit avec tout autre antenne ou
transmetteur.

CE Marking

CE marking on this product represents the product is in
compliance with all directives that are applicable to it.
This equipment is intended to be accessed only by service
personnel and/or trained professionals.
59