Graco 24K337 Instructions - Parts

Instructions - Parts
Light Tower Kit
Diagnostic indicator for use with a Graco Control Architecture (GCA) controlled system.
Kit 24K337
Important Safety Instructions
Read all warnings and instructions in your system
manuals. Save all instructions.
Installation
Install the light tower somewhere it will be visible to the
operator during system use. Light tower must be located
within 10 ft (3 m) of the Advanced Display
Module (ADM) unless an extension cable is used. See
page 2 for available cables.
1. Use lag screws (6) and gasket (2) to install
bracket (1) in desired light tower location.
2. Guide the hard-wired light tower cable through the
opening in the bracket (1) then use screws (3a),
washers (3b), and nuts (3c) to secure light tower to
bracket.
3. Connect supplied accessory cable (5) to hard-wired
light tower cable. Connect other end to open con-
nector on ADM. Route cable so that it is protected
from damage.
Mounting
Surface
(For Refer-
ence Only)
2 1 5
3A1906A
3
3a
3b
3c
ADM
(For Reference Only)
ti18612a
6
EN