Samsung SyncMaster 797MB Owner's Manual page 60

1. General Q & A
Check List
Q & A
Self-Test Feature
Check
How can I change the frequency?
How can I adjust the resolution?
How can I set the Power Saving
function?
The monitor makes a sound when it
is turned on.
How can I clean the outer
case/Picture tube?
2. Highlight Zone III Q & A
The program does not function
properly.
Started a multimedia program but the
Highlight Zone function does not
Question
Question
General Q & A
Answer
Frequency can be changed by reconfiguring the video
card.
Note that video card support can vary, depending on the
version of the driver used.
(Refer to the computer or the video card manual for
details.)
Windows ME/XP/2000: Set the resolution at the Control
Panel, Display, Settings.
* Contact the video card manufacturer for details.
Windows ME/XP/2000: Set the function at BIOS-SETUP
of the computer or the screen saver. (Refer to
Windows/Computer Manual).
This is normal as some sound may be generated when
the metal case and the electromagnet, which are installed
to block any electromagnetic waves, interact with each
other.
Disconnect the power cord and then clean the monitor
with a soft cloth, using either a cleaning solution or plain
water.
Do not leave any remains of the detergent nor scratch the
case. Do not allow any water to go inside the monitor.
Answer
Highlight Zone III features a combination of circuitry and
software built on proprietary technology of SEC.
Therefore, the Highlight Zone III feature is found only on
SEC monitors that support the feature.
Check if your monitor supports the Highlight Zone III
feature.
If not, the Highlight Zone III icon will show a message
saying, "No Connection" (
properly before using it. Neither Automatic Detect or nor
Manual Detect function while the icon shows the
message, "No Connection". You can only exit the
program.
Check the Highlight Zone III menu and see if Disable
Auto Detect is selected.
|
Highlight Zone III Q & A
)Connect the monitor