Operation Procedure - Promac BX-834 Instruction Manual

4.

Operation procedure

Caution
(1) Check the power source
Push the start button to judge the motor and spindle shaft is in normal condition or not.
(2) Speed adjustment
After turn on the power, rotate the speed control switch form min. to max. position. When
rotation the switch, the speed will be changed and the speed value will be displayed in liquid
digital meter. (for electronic LCD type only)
(3) Adjust work table position
Firstly, loose the clamp handle in left hand, then swing the table handle to properly position.
Finally tight the clamp handle.
(4) Adjust the height of work table to properly position, then fix the screw.
The worktable height depends on the working piece volume and height, if a incline angle is
necessary, loss the set screw first, then rotate the angle alignment the scale of the work table.
Finally, tight the set screw, if a vise will be used in the operation same as above, loose the set
screw, turn 180 degrees, let vise on the upside. Finally tight the set screw
(5) There are two T grooves on the worktable. It is used to fix the working piece.
(6) There are two grooves in the base, too. It is convenient for fixed the longer, heavier and larger
working piece.
(7) Secure the working piece on the worktable, as possible locate the working piece in the center
of the worktable.
(8) Complete above caution item and make sure no problem, then select the properly tool for
operation. Refer instruction manual suggestion adopt corrected cutting feed.
(9) Use Spindle Pulley to choose High or Low speed if 2-spped motor is equipped
to the machine.
(10) Before operation, the protected safety guard shall be pushed to proper position. There is a
micro switch in guard, the power will be shut down, when guard does not close well or not
in specified position.
:
Read instruction manual before operating the machine.
11