Table of Contents
Advertisement
Appendix
How to optimize the exposure conditions?
Position the EzSensor and the X-ray source, as shown below. The distance between the cone and the
detector should be 80mm (8cm). Please align the X-ray source over the sensor.
1. Distance: 80mm(8cm) (from cone to detector)
2. Added filter: 4mm Al filter (or No filter )
3. Signal level: after calibration of image
Run program '_EzSensor150' located in C:\EzSensor150
40
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the EzSensor and is the answer not in the manual?