Advertisement
Installation Instructions Product-Ident: 45180
10 Installation of crossover circuit + speaker connection
10.1 Precable crossovers - see wiring diagram.
10.2 Install crossover – without housing; covered with foamed material - in the hollow space between door card and car door (see
fig.) and ensure precise fit.
*Important:
Protect the sheet bar against humidity and observe that the sheet bar does not touch any metal parts – danger of short
circuit!
10.3 Connect all speakers to the crossover circuit according to the wiring diagram.
10.4 Insert woofer and midrange.
10.5 Notice: You should check the polarity of all woofers after having connected them
to the crossover circuit with a 9 volt battery
(input cable on the side of the amplifier):
pole of the crossover circuit input + to + of a 9 Volt battery
pole of the crossover circuit input - to - of a 9 Volt battery
All woofers must move uniformly!
Wrong polarity of a woofer can totally equalize the bass sound!
08.10.09 10:23
Seite 7 von 8
Advertisement
