Advertisement
Installation Instructions Product-Ident: 45180
1 Disassembly of the door card
1.1 Roll down window completely.
1.2 Unclip the grill above the doorhandle and remover the screw underneath (A).
1.3 Unscrew screws B + C1-C2.
1.4 Unclip the lower and lateral edges of the door lining and remove the door card upwards.
1.5 Remove the Bowden pull wire out of the door latch lever.
1.6 Unplug central-switch.
1.7 Car door: disconnect the original loudspeaker plugs and dismount the original woofer (will not be used any more)
2 Tweeter installation A-pillar - original mount - without mounting device
2.1 Dismount the original speaker grill of the A-pillar and the original tweeter. Unplug the connecting cables. (No more need of the
original connecting cable and tweeter).
2.2 Remove the tweeter out of the catch:
---> bayonet catch: turn to the right and pull out of the holding device - by means of the screw.
(no more need of the catch)
2.3 Adapt the JEHNERT-tweeter cable with the speaker cable (1,5 - 4 qmm), lead the cable up to
where the crossover is installed in the car door.
In order to avoid vibration noise insulate all cables with insulating tape e.g.
2.4 Adjust the JEHNERT-tweeter in the original cut-out and affix with hot melt adhesive or silicone on the backside.
2.5 Reinstall the A-pillar.
08.10.09 10:23
Seite 2 von 8
Advertisement
