Advertisement
Installation Instructions Product-Ident: 45180
5 Marking fastening points
5.1 Mark the fixing points 1-5_ premounted in the doorboard:
Pressing the doorboard onto the door card leaves a visible impression of the screws - the fastening positions of the
door card.
Marking of the pre-drilled fastening points 5-10:
Use a thin awl to set the marks on the door card.
6 Handling of door card cut-outs
The cut out behind the speakers are providing the required full volume of the car door:
6.1 Mark the cut outs for the woofers on the door card. Enlarge them approx. 1cm (= approx. outer diameter of the
woofers).
6.2 For a plane alignment of the doorboard also mark the overlapping tray for the cut-out.
IMPORTANT! Check all cut-outs marked:
The fastenings of the doorboard must have to be screwed with the door card!
The fastenings of the door card must not be removed!
6.3 Remove the doorboard again and cut out the positions marked on the door card. Use a compass saw.
ATTENTION!!! Please observe the wiring harness in the car door.
6.4 Drill the bore holes for the M4-screws according to the marks set before - use a 4mm drill and
enlarge to 7-8mm (not for Spax-screws).
08.10.09 10:23
Example
Example
Example
Example
Seite 4 von 8
Advertisement
