Download Print this page

Cisco IR510 Hardware Installation Manual page 8

Wpan gateway and wpan range extender

Advertisement

IR510 WPAN Gateway and IR530 WPAN Range Extender Hardware Installation Guide
IR510 Installation
IR510 Hardware Specifications
Table 2
IR510 Hardware Specifications
Item
Dimensions
Operating ambient temperature range
DC Power Supply
Reset button
Table 3
IR510 Device Interfaces
Item
Alarm port
QMA Antenna Port
RJ45 Fast Ethernet 10/100 port
RJ45 RS232-DCE or RS485 port
RS232 Console port
RS232-DTE port
USB-A (LS/FS/HS) Host port
Table 4
IR510 LEDs
LED
PWR (Power)
SYS (System)
CPU (System)
ALM
Green
OK: All Power
Blinking: Master Controller Unit
(MCU) is running system software
Blinking: CPU is actively running user
application
---
Description
5.9 x 5 x 1.75 (Inches)
-40C to +60 (Celsius)
Supports 12-48Vdc nominal, 9.6-60Vdc maximum range
Allows factory reset when you press button for approximately 5
seconds.
Description
Port has one Isolated input for open and closed relay detection.
900 MHz ISM band, Omni stick, 24 inch, 5 dBi, N(f), Cisco PID
ANT-WPAN-OM-OUT-N.
Panel-mounted, 50-ohm connector for connecting the antenna to
the WPAN gateway.
Supports the IR509 antenna (ANT-WPAN-OM-OUT-N)
Provides 10/100 Mb/s device connections.
Provides user the option to configure either port interface via
software on the same RJ45 port.
RS232 operates in full duplex mode port
RS485 operates in half duplex or full duplex mode.
Use the
IoT Field Network Director (FND) 4.1 (and higher) User
Guide
to configure the port and provide statistics about the serial
port including bytes sent and received information.
To access the console port, remove the front cover.
Provides for direct connection to a DCE port. Use the
IoT Field Network Director (FND) 4.1 (and higher) User Guide
configure the port and get statistics about the port including bytes
sent and bytes received information.
Supports the following signaling rates: 1Mb/s (low speed), 12Mb/s
(full speed) and 480 Mb/s (high speed).
Yellow
OK: 12K PSU only
Blinking: MCU is booting up
Blinking: CPU is booting up
---
8
to
Red
---
---
---
Solid: Alarm Detected

Hide quick links:

Advertisement

loading

This manual is also suitable for:

Ir530