Cisco IR510 Hardware Installation Manual page 18

IR510 WPAN Gateway and IR530 WPAN Range Extender Hardware Installation Guide
IR530 Series Resilient Mesh Range Extender Installation
Table 9 IR530 Product IDs
Product ID
IR530-OFDM-FCC/K9
IR530-OFDM-BRZ/K9
IR530-OFDM-ANZ/K9
IR530 Range Extender Cautions and Warnings
CAUTION : Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not stack routers on a
desktop. Excessive weight on top of the router could damage the chassis.
CAUTION : Do not install the router or power supplies next to a heat source of any kind, including heating vents.
WARNING : Read the installation instructions before connecting the system to the power source. Statement 1004
WARNING : This product relies on the building's installation for short-circuit (over current) protection. Ensure that the protective device is
rated not greater than: 5 Amps. Statement 1005
WARNING :This unit is intended for installation in restricted access areas. A restricted access area can be accessed only through the use of
a special tool, lock and key, or other means of security. Statement 1017
WARNING :This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably
installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable
grounding is available. Statement 1024
WARNING : Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030
WARNING : Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
WARNING :To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended ambient
temperature of: 60C Statement 1047
WARNING : Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can come into contact
with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits, because they may cause
serious injury or death. For proper installation and grounding of the antenna, please refer to national and local codes (for example,
U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
WARNING : No user-serviceable parts inside. Do not open. Statement 1073
WARNING : This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory compliance and
legal requirements may apply for direct connection to the Cable Distribution System. This product may connect to the Cable Distribution
System ONLY through a device that is approved for direct connection. Statement 1078
IR530 Range Extender Hardware Specifications
Table 10 on page 19 provides a highlight of the hardware specifications. For more details on product offerings such as antennas, cables, and
RF accessories as well as software specifications, compliance, immunity, emissions, safety and ingress protections (dust and water), please
refer to the Cisco IR530 Series Resilient Mesh Range Extenders Data
Description
IR530 with 915MHz-WPAN, utility-grade DC power. For all
North and South America except Brazil.
IR530 with 915MHz-WPAN, utility-grade DC power. For Brazil.
IR530 with 915MHz-WPAN, utility-grade DC power. For
Australia and New Zealand.
Sheet.
18