Advertisement
IR510 WPAN Gateway and IR530 WPAN Range Extender Hardware Installation Guide
IR510 Installation
IR510 Product IDs and Accessories
Product ID
IR510-OFDM-FCC/K9
IR510-DINRAIL=
ANT-UN-MP-OUT-QMA
ANT-UN-MP-OUT-QMA=
ANT-WPAN-OM-OUT-N
IR510 Cautions and Warnings
CAUTION: Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not stack routers on a
desktop. Excessive weight on top of the router could damage the chassis.
CAUTION: Do not install the router or power supplies next to a heat source of any kind, including heating vents.
CAUTION: This equipment is intended to be grounded to comply with emission and immunity requirements. Ensure that the switch
functional ground lug is connected to earth ground during normal use. Statement 1064
WARNING : Read the installation instructions before connecting the system to the power source. Statement 1004
WARNING: This product relies on the building's installation for short-circuit (over current) protection. Ensure that the protective device is
rated not greater than: 5 Amps. Statement 1005
WARNING: This unit is intended for installation in restricted access areas. A restricted access area can be accessed only through the use of
a special tool, lock and key, or other means of security. Statement 1017
WARNING: Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030
WARNING: Connect the unit only to DC power source that complies with the Safety Extra-Low Voltage (SELV) requirements in IEC 60950
based safety standards. Statement 1033
WARNING: Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040
WARNING: Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can come into contact
with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits, because they may cause
serious injury or death. For proper installation and grounding of the antenna, please refer to national and local codes (for example,
U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
WARNING: No user-serviceable parts inside. Do not open. Statement 1073
WARNING : This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory compliance and
legal requirements may apply for direct connection to the Cable Distribution System. This product may connect to the Cable Distribution
System ONLY through a device that is approved for direct connection. Statement 1078
Additional Information for Installation in a Hazardous Environment (IR510 Only)
CAUTION: This equipment is only suitable for use in Class I, Division 2, Groups A, B, C, D, or nonhazardous locations.
CAUTION: For the WPAN gateway, connect only to an NEC Class 2 power source or limited power source as defined by IEC 60950-1.
WARNING: Exposure to some chemicals could degrade the sealing properties of materials used in the sealed relay device. Statement 381
WARNING: Failure to securely tighten the captive screws can result in an electrical arc if the connector is accidentally removed. Statement
397
Description
Cisco 510 WPAN Industrial Router
DIN Rail assembly (spare)
Antenna with QMA connector and 5 ft. cable for use with IR510
Antenna with QMA connector and 5 ft. cable for use with IR510 (spare)
Omni antenna for 900MHz WPAN (Outdoor)
4
Hide quick links:
Advertisement
