Advanced Tabs; Data; Focus - CamRanger User Manual

Advanced Tabs
There are four tabs providing advanced informaIon or controls: Data, Focus, Timer, and HDR. A
Tripod or StackShot tab will appear as a fifh tap if the CamRanger is being used with the CamRanger
PT Hub and a supported tripod head (the MP-360, Bescor, or Hague) or StackShot.

Data

The data tab shows an RGB histogram and meta-data
associated with the captured image in the main image view.
The following meta-data is provided:
• ShuKer Speed
• Aperture
• MegaPixels (Note this is not file size, but image
resoluIon)
• ISO
• Metering Mode
• Exposure CompensaIon Value
Within live view the histogram can be toggled on or off. Of
note, the histogram will reduce the live view frame rate.

Focus

The focus tab is only enabled during live view and provides advanced focusing controls.
Focus Adjust
There are two sets of buKons to move the lens' focal plane
nearer or further from the camera. Each set has three buKons
with different sized arrows to specify a large, medium, or small
step in focus. Tap the buKon to move the focus by a single
increment, holding down the buKon will have no affect.
Focus Stacking
Focus stacking is a process of taking mulIple captures with
slight changes in focus and then post processing them to
enhance the depth of field. This control allows the user to set
the focus step size to take between in each shot and the number
of shots to take. Each focus step will move the focal plane
further from the camera. So the user will want to set the focus
to the nearest plane desired to be in focus and start the stacking
process from there. If too few captures were taken, the process
can be restarted from where the iniIal stacking ended. Note:
post processing of the images is not done within the CamRanger applicaIon.
© CamRanger – Patent Pending
9