Configuring Qos In Dscp Based Mode - TP-Link TL-SG105E User Manual

Configuring QoS
Follow these steps to configure QoS in 802.1P based mode:
1) Select QoS mode as 802.1P Based.
QoS Mode
2) Click Apply.

2.3 Configuring QoS in DSCP Based Mode

Choose the menu QoS > QoS Basic to load the following page.
Figure 2-3 Configuring Basic QoS in DSCP Based Mode
Follow these steps to configure QoS in DSCP based mode:
1) Select QoS mode as DSCP Based.
QoS Mode
2) Click Apply.
Select the QoS mode.
802.1P Based: In 802.1P based mode, the tagged packets are mapped to 4
priority levels based on the Pri value in 802.1Q tag (Lowest = 1, 2; Normal =
0, 3; Medium= 4, 5; Highest = 6, 7). The switch only prioritizes packets with
VLAN tag, regardless of the IP header of the packets.
Select the QoS mode from the drop-down list.
DSCP/802.1P Based: In DSCP based mode, the IP packets are mapped to
4 priority levels based on the DSCP value (Lowest= 0-15; Normal = 16-31;
Medium = 32-47; Highest = 48-63). The switch prioritizes packets with IP
header based on DSCP priority first. Then, the switch prioritizes packets
with VLAN tag but without IP header base on the PRI field. Finally, the
switch prioritizes packets without VLAN tag or IP header based on port
priority.
Configuring Basic QoS
User Guide 63