Removing The Oil Pump - Yamaha SL338D Service Manual

.
.
.
:-
. .
I • '
I •
•
•
.. .
• • , • t
I I •
'• .
'
.
.
:.
.
.
.: .
I
. !
•
•
ENGINE·
Removal of Primary Sheaves, Removing the Oil Pump
2-3-5
A
taper-fit holds the inner primary sheave to the shaft.
A special tool is used to pull the inner sheave off the shaft.
This tool is the same one that was used to remove the
special tool in place rather than the short ones.
As
you will notice in the picture, a wrench is used to hold
the special tool so that it will not turn as the T-handle is
saewed in.
Fig.
2-43
2-4 REMOVING THE OIL PUMP
2 4 1
Remove the two oil delivery pipe from the oil pump.
--
a
)
\
Fig. 2-44
2-4-2
Remove the four 10 mm bolts and one hexago n bolt, and
remove the oil pump drive gear cover.
The oi l pump can be removed, together with the oil pump
drive gear cover.
Fig. 2-45
0
Fig. 2-46
2-4-3
Remove the two panhead screws, and rem ove the oi l pump
from the oil pump drive gear cover .
Fig. 2-47
•
-38-