Bolton Tools ZX45A Operating Manual page 8

rotate it slightly counter-clockwise to loosen the gib trip.
(4)Adjust the gib trip bolt until very slight drag is felt when moving
the table.
6. Changing machine speed
(1)Turn the power off.
(2)To select the proper speed, move the handle(1) to the desired position .
(3)If the gear are not engaged, remove the arbor bolt cover. rotate the
spindle slightly to engage the gears, then replace the arbor bolt cover.
(4)Recheck the handle setting, then turn the power on.
RPM
HZ
50HZ
60HZ
7.Installing and changing tools
WARNING: BE SURE THE POWER IS TURNED OFF AND THE MACHINE
(1)Removing face mill or drill chuck arbor.
Loosen the arbor bolt at the top of the spindle shaft approximately
2 turns with a wrench.rap the top of the arbor bolt with a mallet. After
taper has been broken loose, holding chuck arbor on a hand and turn
the arbor bolt with the other hand.
(2)To install face mill or cutter arbor
Insert cutter and cutter arbor into the taper of spindle. Tighten arbor
bolt securely, but do not overtighten.
(3)Removing taper drills
(a) Turn down the arbor bolt and insert the taper drill into the spindle
shaft.
(b) Turn down the rack sleeve until the oblong hole in the rack sleeve
appears, lock the rack sleeve, insert wedge though holes and strike
lightly with a mallet, this will force the taper drill out.
8.Ordering replacement parts
Complete parts list is attached , if parts are needed, contact your local
distributor.
9.Additional tools and accessories you will find helping
Each of machine is equipped with a M.T.3 or R8 ,contact your local
distributor or a main cutting tool distributor to obtain any of these
accessories.
Taper drill
Reamers
80 145
95 175
UNPLUGGED BEFORE INSTALLING OR CHANGING TOOL BITS.
260 375
310 450
8
710 1250
850 1500