Maintenance - Bolton Tools ZX45A Operating Manual

(d)The machine may not be stable in the floor--- be sure the machine
is firmly mounted to the floor.

MAINTENANCE

1. After each use
(a) Turn off the power switch.
(b) Remove any tool bits, clean and lubricate them, and return them
to their storage case.
(c) Using a stiff bristle brush, brush off all chips.
(d) Using a rag, wipe off any excess or dirty oil or cutting fluid
left on the machine.
(e) Lubricate the points, apply light greese or oil to all unpainted
metal to prevent corrosion.
(f) Cover the machine to prevent dust or dirt contamination when not
in use.
2. Daily maintenance
(a) Fill the oil reservoir to the proper level before each use
(b) Check the tightness of the bolts holding the head in place.
(c) If overheating or unusual noises are produced, stop the machine
immediately to check for lack of lubrication, faulty adjustments,
dull tool bits or other deficiencies, correct any problems
before resuming work.
(d) Keep the work area clean.
3. Weekly maintenance
(a) Clean and coat the lead screw with oil.
(b) Check the lubrication of the sliding parts of the table. apply
light greese if needed.
4. Monthly maintenance
(a) Adjust the accuracy of the slides on both the cross and
longitudinal feeding.
(b) Lubricate the bearings, worm gear and worm shaft with light
grease.
5. Yearly maintenance
Adjust the table to assure that it is level in all directions.
(a)
Check the electrical cord, plug, circuit breakers and related
(b)
connections to assure that they are secure and safe.
Drain the lubricant from the gear box and replace it.
(c)
12